Preparation

• Remove Furniture and Obstacles: Ensure the area is clear of furniture, rugs, and any other items. (client’s responsibility)
• Place Wet Floor Signs: Clearly mark the area to prevent foot traffic and potential accidents.
• Sweep or Vacuum the Floor: Remove all dust, debris, and loose dirt from the floor surface.

Stripping the Floor

• Mix Floor Stripper Solution: Follow the manufacturer’s instructions to mix the floor stripper with water in a bucket.
• Apply Stripper Solution: Use a mop to generously apply the solution to a manageable section of the floor. Do not saturate the floor; ensure even coverage.
• Allow Solution to Dwell: Let the stripper solution sit for the time recommended by the manufacturer, typically 5 to 10 minutes. Do not let it dry on the floor.
• Scrub the Floor: Use a floor scrubbing machine with a stripping pad to agitate the floor surface. For corners and edges, a hand scrubber may be necessary.
• Remove Old Finish: Use a wet vacuum to remove the slurry, or mop it up with a clean mop and bucket. Rinse the floor with clean water and remove the rinse water with a wet vacuum or mop. Repeat if necessary until all residues are removed.
• Let the Floor Dry Completely: Ensure the floor is completely dry before proceeding to the next steps. Use fans or air movers to speed up the drying process if needed.

Sealing the Floor (Optional)

• Apply Sealant (If Using): Some floor finishes act as both sealant and wax, while others require a separate sealant. If using a separate sealant, apply it evenly with a finish mop. Allow it to dry according to the product instructions, typically 30 minutes to an hour.
• Apply Additional Coats: Depending on the product and desired level of protection, apply 1-2 additional coats, allowing each coat to dry thoroughly.

Waxing the Floor

• Apply Floor Finish: Pour the floor finish into a clean bucket and apply it with a clean finish mop. Work in small sections, using a figure-eight motion to ensure even coverage.
• Allow to Dry: Wait for the floor to dry completely, which can take 30 minutes to an hour, depending on humidity and air circulation.
• Apply Multiple Coats: For best results, apply at least 2-3 coats of finish, allowing each coat to dry thoroughly before applying the next. The number of coats can vary based on the product used and the desired level of shine and protection.

Post-Application

• Buff or Burnish the Floor (Optional): Once the final coat of wax is dry, some facilities choose to buff or burnish the floor to enhance the shine.
• Clean Up: Clean all tools and equipment with water (if water-based products were used). Properly dispose of or recycle product containers.
• Return Furniture and Remove Signs: Once the floor is dry and safe to walk on, carefully return furniture and other items to their places and remove all signage. (Responsibility of the client)

Maintenance

• Regular Cleaning: Maintain the floor’s appearance with regular sweeping, mopping, and spot cleaning.
• Periodic Top Coating: Depending on traffic and wear, the floor may need periodic top coating to maintain its shine and protective layer.